Bowflex TreadClimber TC100 Service Manual page 55

5. Using a 4mm hex wrench and a 13mm (1/2") wrench, remove the 6
indicated screws from the Motor Compartment Cover.
6. Unplug the lower Input/Output (I/O) Cable from the Motor Control
Board.
Note: The Motor Control Board is located under the Right Treadle.
7. Plug in the new lower I/O Cable to the Motor Control Board.
8. Using a piece of wire or string, connect the loose ends of the new
lower I/O Cable and the old lower I/O Cable. The old cable will pull the
new cable into place when removed.
9. Using a 5mm hex wrench, remove the six bolts in the indicated areas
(three visible in image) that secure the Console/Handlebar Assembly.
Lower Input/Output
Cable
55