Table of Contents
Advertisement
16. Installation is the reverse procedure.
Wrap the new Drive Belt around the Motor Pulley. Start the Drive Belt on the Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not
come off of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the Pulleys.
Roll the Drive Pulley clockwise until the Drive Belt is fully installed. Continue to roll the Belt forward while adding side pressure with fingers to align as
necessary.
17. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
DRIVE MOTOR
GROUND
MOTOR TO FRAME
(GREEN WITH YELLOW STRIPE)
TACH SENSOR
RED
POWER
MCB TO MOTOR
GROUND
INLET TO FRAME
(GREEN WITH YELLOW STRIPE)
TACH CABLE
TWISTED (RED/BLACK/BLUE)
1 TWIST PER INCH
BLACK
POWER
ENCLOSURE
64
COMMUNICATION CABLE
TO CONSOLE (GREY)
MOTOR CONTROL
BOARD
GROUND
MOTOR TO FRAME
WHITE
(GREEN WITH YELLOW STRIPE)
POWER
BLACK
INCLOSURE TO MCB
1 TWIST PER INCH
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
