Bowflex TreadClimber TC100 Service Manual page 76

25. Reassembly is the reverse procedure.
Wrap the Drive Belt around the Motor Pulley. Start the Drive Belt on the
Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not
come off of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning
the Pulleys.
Roll the Drive Pulley clockwise until the Drive Belt is fully installed.
Continue to roll the Belt forward while adding side pressure with fingers
to align as necessary.
Note: Be sure to tighten the Belt Tensioning Screws the number of turns
previously recorded.
The walking belts need to be adjusted if they are out of center enough
to cause a rubbing or scraping sound. Adjustments can be made at the
Front Roller of each Treadle.
Adjusting the Walking Belts – While operating the machine, notice
where the belts run on each Treadle. The Walking Belt Adjustment Bolts
are on the front end of each Roller. If the belt is tracking too far to the
right, use a properly sized Hex Key to turn the right adjustment bolt
clockwise on that belt in full turn increments. If the belt tracks too far to
the left, do the same thing on the left adjustment bolt.
Note: Do not turn the bolts counterclockwise when you adjust
the belt alignment.
Belt Tension Adjustment – Check the belt tension only when the
machine is unplugged. From the belt's midpoint, a correctly tensioned
belt should only have an inch of give. To check, pull the belt upward
at its midpoint and measure the distance to the deck. If the distance is
more than an inch, the belt is loose. To tighten, turn both Walking Belt
Adjustment Bolts clockwise one-half a turn and check tension again.
Repeat this step if necessary.
Note: Bolts are turned counterclockwise equally to decrease
belt tension.
26. Final Inspection
Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
Drive Pulley
Motor Pulley
76
Drive Belt