Bowflex TreadClimber TC100 Service Manual page 80

11. Remove the lower mounting bolt from the Cylinders. Leave the tops
attached.
12. Disconnect the Cylinders from the Treadles, and lower each Treadle
gently.
The Treadle will fall abruptly if not supported. Keep hands
away from the inside of the Treadles to avoid possible
serious injury.
13. Using a 13mm (1/2") wrench, remove the 8 indicated bolts from both
sides of the Treadle Assembly.
14. Carefully lift the Treadle Assembly off of the machine.
Note: THIS STEP REQUIRES TWO PEOPLE.
Do not move the machine without aid. Injury to you or
damage to the machine can occur. The Treadles and Walking
Belts can abruptly move. To avoid possible serious injury,
keep hands away from the inside of the Treadles and the
edges of the Walking Belts.
The Treadle will fall abruptly if not supported. Keep hands
away from the inside of the Treadles to avoid possible
serious injury.
The Walking Belts can abruptly move. To avoid possible
serious injury, keep hands away from the edges of the
Walking Belts.
15. Reassembly is the reverse procedure.
Wrap the new Drive Belt around the Motor Pulley. Start the Drive Belt on
the Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not
come off of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the
Pulleys.
Roll the Drive Pulley clockwise until the Drive Belt is fully installed.
Continue to roll the Belt forward while adding side pressure with fingers to
align as necessary.
80