NOTICE: Always use a 100% pure silicone lubricant. Do not use a degreaser like WD-40
this could seriously impact performance.
Note: The Walking Belts may need to be loosened to allow for access during lubrication. Consult the "Adjusting the Walking Belts" procedure
if necessary.
3. Connect the power cord back into the machine and then into the wall outlet.
4. Stay to one side of your machine.
5. Switch on your machine and start the belts at the slowest speed. Let the belts operate for approximately 15 seconds.
6. Switch off your machine.
7. Take care to clean up any excess lubricant from the Treadles. We also recommend a periodic inspection of the Treadle surfaces below the belts.
If the decks appear worn, contact a Customer Service Representative.
To decrease the possibility of slipping, be sure the Treadle area is free from grease or oil. Clean off any excess oil from the machine
surfaces.
spray lubricant or a petroleum based product as
®
8