Bowflex TreadClimber TC100 Service Manual page 56

10. Slightly remove the Console/Handlebar Assembly from the Right
Upright and disconnect the Upper and Lower I/O Cables. When discon-
nected, fully remove the Console/Handlebar Assembly while not allowing
the I/O Cable to fall into the Right Upright.
This step may require two people.
11. Place the Console/Handlebar Assembly onto something that will
protect it from marking or damage, such as a blanket.
12. Using a piece of wire or string, connect the loose ends of the new up-
per I/O Cable and the old upper I/O Cable. The old cable will pull the new
cable into place when removed.
Note: Images displayed may be different from current configuration.
13. Using a 5mm hex wrench, remove the four indicated screws that
secure the Main Console Assembly.
14. Gradually slide the Main Console Assembly from the Handlebars.
Be sure to guide the new upper I/O Cable and not crimp any Cables as
they come free from the Assembly.
Note: Do not crimp the cables.
56