Bowflex TreadClimber TC100 Service Manual page 92

20. Using a 13mm (1/2") wrench, remove the 2 indicated bolts from the
Right Side Bearing Plate and remove it from the Rear Roller.
21. Carefully slide the Walking Belt off of the deck.
22. Follow the same procedure for replacing the left Walking Belt.
23. Installation is the reverse procedure.
Note: Be sure to tighten the Belt Tensioning Screws the number of turns
previously recorded.
24. Once the machine has been reassembled, the Walking Belts will
need to be properly tensioned.
Check the belt tension only when the machine is un-
plugged.
To check, pull a Walking Belt upward at its midpoint and measure the
distance to the deck. If the distance is more than an inch, the belt is
loose. To tighten, turn both of the Belt Tensioning Screws clockwise
one-half a turn equally and check the tension again. Repeat this step as
necessary on both Belts. Be sure not to over-tighten the belts.
Note: Bolts are turned counterclockwise equally to decrease belt ten-
sion.
Rear Roller
92
Right Side Bearing Plate