Installation; General Instructions For Installation; Bus Node Settings - Festo MSE6-E2M Mounting, Installation, Commissioning

3 Mounting and installation
3.5

Installation

3.5.1

General instructions for installation

Warning
Uncontrolled movements of the connected actuator technology and loose tubing can
cause injury to persons and/or damage to property.
• Before carrying out installation and maintenance work, switch off the following:
– Compressed air supply including venting of the system
– Operating and load voltage supplies.
Warning
Risk of injury due to residual pressure
When the input pressure is being switched off (e.g. during a venting procedure), a resid­
ual pressure of P2  1 bar (P2  0,1 MPa) can remain at the output of the MSE6-E2M.
• Use appropriate measures to ensure that the residual pressure does not result in a
hazard.
3.5.2

Bus node settings

Each bus node has a service interface. Additional electric interfaces, setting and display components
are available, depending on the bus node used. A detailed description of the equipment characteristics
can be found in the corresponding brief description of the bus node (è Tab. 1) or in the system descrip­
tion for the energy efficiency module (è MSE6-E2M-SY-...).
20 Festo – MSE6-E2M-IN-EN – 2017-07c – English