Dismounting - Festo MSE6-E2M Mounting, Installation, Commissioning

3 Mounting and installation
3.4

Dismounting

Warning
Switch off the following before dismounting the MSE6-E2M:
• Compressed air supply including venting of the system
• Operating and load voltage supplies.
Warning
Risk of injury due to residual pressure
When the input pressure is being switched off (e.g. during a venting procedure), a resid­
ual pressure of P2  1 bar (P2  0,1 MPa) can remain at the output of the MSE6-E2M.
• Use appropriate measures to ensure that the residual pressure does not result in a
hazard.
Warning
Loads which suddenly fall down may cause injury to people.
• Take the product's weight into account. The MSE6-E2M has a product weight of
max. 3.5 kg.
Dismount the MSE6-E2M in this sequence:
1. Remove the fieldbus cable from the bus node.
2. Remove the electrical connection cable.
3. Remove the earth connection.
4. Loosen the pneumatic connections.
5. Loosen the screws from all mounting brackets, one after the other. Start with the screws beneath
the MSE6-E2M.
6. Remove the complete MSE6-E2M.
Festo – MSE6-E2M-IN-EN – 2017-07c – English 19