Combination With Ms6 Modules - Festo MSE6-E2M Mounting, Installation, Commissioning

3 Mounting and installation
3.3

Combination with MS6 modules

Note
Observe the notes regarding installation and commissioning of MS6 modules in the
corresponding documentation.
Note
Observe the maximum permissible number of ten individual modules for the overall
combination. The MSE6-E2M counts as a double module here.
Note
When supplementing MS6 modules, only use the MS6-WPG wall mounting and the
MS6-MV-EX module connector.
Note
Observe the notes regarding the procedure for left and/or right-hand side assembly of
maintenance modules, as described in the assembly instructions for the MS6-WPG wall
mounting set.
Note
Please note that when using a MS6-SV-D, a MS6-WPG wall mounting set may not be
mounted on the right-hand side due to a mechanical conflict with the sensor cables.
Alternatively, an MS6-FRM-FRZ distributor block can be inserted.
Note
Please note that in the case of a larger device configuration, a longer FE connection is
required.
For the left and/or right-hand side supplement of the MSE6-E2M with MS6 modules, proceed as follows:
1. Use an MS6-WPG wall mounting set for MS6 individual modules or, in the case of pre-assembled
MS6 combinations, replace the MS6 wall brackets with the wall mounting set.
2. For MS6 individual modules use MS6-MV-EX module connectors or, in the case of pre-assembled
MS6 combinations, replace all of the standard module connectors with these module connectors.
For a left-hand supplement, proceed as follows:
3. Remove the left-hand pneumatic base plate of the MS6 module or MS6 module combination re­
spectively and assemble the left-hand pneumatic base plate of the MSE6-E2M at this point.
4. Connect the earth terminal on the left-hand pneumatic base plate with low impedance (short cable
with large cross section) to the left end plate of the electrical interlinking module of the MSE6-E2M.
Festo – MSE6-E2M-IN-EN – 2017-07c – English 17