Network And Web Access Configuration - YASKAWA CIMR-V7AM Technical Manual

Network and Web Access Configuration

Configure the EtherNet/IP Network
1. The default configuration option for the EtherNet/IP Option Kit is DHCP (Dynamic Host Configuration Protocol). Thus there must be a
DHCP Server connected to the network in order to set the IP address of the EtherNet/IP Option Kit. For detailed information on how to
setup the Rockwell BOOTP/DHCP Server on a PC refer to the appropriate Rockwell document or Yaskawa's Application Note
AN.AFD.10.
2. If the network configuration requires that devices have a static IP address, the EtherNet/IP Option Kit's configuration can be changed to
USER and the appropriate static IP address can be entered via the EtherNet/IP Option Kit's web pages as shown below.
Note that the EtherNet/IP Option Kit must first have been assigned an IP address via DHCP before its configuration can be changed.
Connect to the V7 EtherNet/IP Option Kit
1. Direct connection: To connect directly to the V7 EtherNet/IP Option Kit plug one end of a shielded CAT-5 (or better) EtherNet/IP
cross-over cable into the RJ-45 socket on V7 Drive. Connect the other end to the RJ-45 Ethernet socket on the configuration device,
typically a controller, laptop or other PC.
2. Connection through hub or switch: To connect through a switch, hub or router, connect a standard shielded CAT-5 (or better) patch
cable to the RJ-45 socket on the V7 Drive. Connect the other end to the switch, hub or router.
3. Attach the provided ferrite to a looped Ethernet cable as close to the connection on the V7 drive as possible. Secure the ferrite in place
with the provided cable tie.
4. Attach the provided ferrites to the V7 motor leads and to the V7 power leads as close to the V7 motor and power terminals as possible
(typically within 1 foot). Secure the ferrites to the motor and power leads with the provided cable ties.
Fig 1.5 – Install Ferrites
Installation 1-9