Table of Contents
Advertisement
Install the V7 EtherNet/IP Option Kit
1.
Wire the V7 Drive I/O terminals prior to mounting the V7 EtherNet/IP Option Kit, as the option will obscure the terminals
when mounted.
2.
Mount the V7 EtherNet/IP Option Kit on the V7 Drive.
2.1
Do NOT connect a ground wire to the screw on the back of the option kit.
2.2
Align the CN1 connector on the back of the option with its mating CN2 connector on the front of the V7 Drive.
2.3
Simultaneously align connector CN3 (male RJ-45) on the back of the option with connector CN1 (female RJ-45)
on the front of the V7 Drive.
2.4
Align the tabs on the option with their corresponding slots on the front of the V7 Drive.
2.5
Press the option and the V7 Drive together until the tabs lock into their associated slots.
2.6
Secure the option to the V7 Drive by tightening the locking screw at the top-center of the option.
2.7
Reinstall the operator keypad and all V7 Drive covers.
Fig 1.3 – Install the V7 EtherNet/IP Option Kit
Installation 1-5
Hide quick links:
Advertisement
Table of Contents
