GE RSTi-EP User Manual page 391

Standalone 1ghz programmable controller

Hide thumbs Also See for RSTi-EP:

Table of Contents

4. If the existing electronic unit was coded, insert the new coding pins into the coding seats

located in the base module.

5. Hold the new electronic unit by the top and the bottom, and carefully slide it into the base

Note: The electronic units are functionally coded so that they can only be inserted into the

appropriate base module. If it is not possible to insert a new electronic unit into the base

module, check if the combination is correct and if there is a possible mix-up.

RSTi-EP User Manual

Chapter 10 Replacing Components