Cable Protection - GE RSTi-EP User Manual

1.5.3 Cable Protection

The modules listed in the following table do not have a fused sensor/actuator power supply. Here, all
cables to the connected sensors/actuators must be fused corresponding to their conductor cross-
sections (as per Standard DIN EN 60204-1, section 12).
Description
Digital Input, 4 Points, Positive Logic 24VDC, 2,3, or 4 Wire
Digital Input, 8 Points, Positive Logic, 24VDC 2 Wire
Digital Input, 8 Points, Positive Logic, 24VDC 3 Wire
Digital Input, 4 Points, Positive Logic 24VDC, 2,3, or 4 Wire, Time stamp
Digital Input, 4 Points 110/230 VAC (65 – 277 VAC), 2 Wire, Isolated
Digital Output, 4 Points, Positive Logic 24VDC, 0.5A, 2,3, or 4 Wire
Digital Output, 4 Points, Positive Logic 24VDC, 2.0A, 2,3, or 4 Wire
Digital Output, 4 Points, Positive/Negative Logic 24VDC, 2.0A, 2,3, or 4 Wire
Analog Input, 4 Channels Voltage/Current 16 Bits 2, 3, or 4 Wire
Analog Input, 4 Channels Voltage/Current 12 Bits 2, 3, or 4 Wire
2 Channels PWM Output, Positive Logic, 24VDC, 0.5 A
2 Channels PWM Output, Positive Logic, 24VDC, 2 A
1 Channel High Speed Counter, AB 100 kHz 1 DO 24VDC, 0.5A
2 Channel High Speed Counter, AB 100 kHz
2 Channel Frequency Measurement, 100 kHz
1 Channel Serial Communications, 232, 422, 485
1 Channel SSI Encoder, BCD or Gray-Code Format, 5/24 VDC
Power Module, 16 Channels 24VDC Potential Distribution +24 VDC from Input Current Path
Power Module, 16 Channels 24VDC Potential Distribution +24 VDC from Output Current Path
Power Module, 16 Channels 24VDC Potential Distribution +0VDC from Input Current Path
Power Module, 16 Channels 24VDC Potential Distribution +0VDC from Output Current Path
GFK-2958E
Digital input modules
Digital output modules
Analog input modules
Functional modules
Potential distribution modules
RSTi-EP User Manual
Chapter 1: Introduction
Order No.
EP-1214
EP-1218
EP-1318
EP-12F4
EP-1804
EP-2214
EP-2614
EP-2634
EP-3164
EP-3124
EP-5422
EP-5442
EP-5111
EP-5112
EP-5212
EP-5261
EP-5311
EP-711F
EP-751F
EP-710F
EP-750F
15