Mitsubishi Electric Q170MSCPU User Manual page 179

6 INSPECTION AND MAINTENANCE
Replacing Battery
Turn off the Motion controller's power
supply.
Pull the battery holder while pushing
the battery holder fixing tab, and
remove the holder from the Motion
controller.
Remove the battery lead connector
from battery connector.
Remove the lead wire from the lead
wire fixing hook.
Remove the old battery from the
battery holder.
Set the new battery to the battery
holder correctly after confirming "+"
side and "-" side for the battery.
Anchor the lead wire to the lead wire
fixing hook.
Connect the battery lead connector
to the battery connector.
Adjust the battery holder to the
installation grooves, and slide the
battery holder in the direction of the
arrow, taking care to not damage the
lead wires.
(Be sure to insert it until it clicks.)
Turn on the Motion controller's power
supply.
END
(1) Q6BAT
1), 2)
3)
(Note)
4)
5)
6)
7)
Push 1)
Remove
5)
4)
Battery
(Q6BAT)
" - " side
6)
(Note): Do not pull on the lead wire forcibly to remove the connector.
6 - 12
Motion controller
Battery holder
Battery holder fixing tab
2)
Pull
Battery connector
(Q170MSCPU side)
Battery lead
3)
connector
(Note)
(Battery side)
Lead wire fixing hook
4)
" - "
side
Top face of battery holder
" + " side
Installation grooves
7)
Push
" + "
side
Battery holder