Download  Print this page

Installation And Removal Of Module To The Base Unit - Mitsubishi Electric Q170MSCPU User Manual

Melsec q series, motion controller.
Hide thumbs

Advertisement

4 INSTALLATION AND WIRING

4.1.3 Installation and removal of module to the base unit

Securely insert the module
fixing projection into the
module fixing hole so that the
latch is not misaligned.
Using the module fixing hole
as a fulcrum, push the module
in the direction of arrow to
install it into the base unit.
Make sure that the module is
installed in the base unit
securely.
When using module in a place
where there is large vibration
or impact, install them by the
unit fixing screws.
END
This section describes how to install and remove a Motion module, I/O module,
intelligent function module or another module to and from the base unit.
(1) Installation and removal of the module from base unit
(a) Installation
Base unit
Module
connector
Module
fixing
projection
Module fixing hole
Module
fixing
projection
Base unit
Module fixing
hook
Module
Module
mounting
lever
Module fixing hole
4 - 10
Base unit
Module
mounting lever
Module
fixing
projection
Module fixing hole
Base unit
Module
fixing
projection
Module fixing hole

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric Q170MSCPU

   Related Content for Mitsubishi Electric Q170MSCPU

This manual is also suitable for:

Q170mscpu-s1

Comments to this Manuals

Symbols: 0
Latest comments: