General Specifications - Mitsubishi Electric Q170MSCPU User Manual

2 SYSTEM CONFIGURATION

2.4 General Specifications

Item
Operating ambient temperature
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating ambience
(Note-1)
Operating altitude
Mounting location
(Note-2)
Overvoltage category
(Note-3)
Pollution level
(Note-1): Do not use or store the Motion controller under pressure higher than the atmospheric pressure of altitude 0m. Doing so can cause
an operation failure. When using the Motion controller under pressure, please contact with our sales representative.
(Note-2): This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical
power distribution network and the machinery within premises.
Category applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300V is 2500V.
(Note-3): This index indicates the degree to which conductive material is generated in terms of the environment in which the equipment is
used.
Pollution level 2 is when only non-conductive pollution occurs. A temporary conductivity caused by condensing must be expected
occasionally.
The Motion controller must be stored and used under the conditions listed in the table of
specifications above.
When not using the module for a long time, disconnect the power line from the Motion controller
or servo amplifier.
Place the Motion controller and servo amplifier in static electricity preventing vinyl bags and store.
When storing for a long time, please contact with our sales representative.
Also, execute a trial operation.
General specifications of the Motion controller are shown below.
Under
Compliant with
intermittent
JIS B 3502 and
vibration
IEC 61131-2
Under
continuous
vibration
Compliant with JIS B 3502 and IEC 61131-2 (147m/s
Specification
0 to 55°C (32 to 131°F)
-25 to 75°C (-13 to 167°F)
5 to 95% RH non-condensing
,
5 to 95% RH non-condensing
,
Constant
Frequency
acceleration
5 to 8.4Hz
9.8m/s
8.4 to 150Hz
5 to 8.4Hz
4.9m/s
8.4 to 150Hz
No corrosive gases
2000m(6561.68ft.) or less
Inside control panel
II or less
2 or less
CAUTION
2 - 21
Half amplitude
3.5mm
——
(0.14inch)
2
——
1.75mm
——
(0.07inch)
2
——
2
, 3 times in each of 3 directions X, Y, Z)
Sweep count
10 times each in
X, Y, Z directions
—