Siemens SIRIUS ACT 3SU1 System Manual page 310

IO-Link 3SU14
12.1 Configuring the IO-Link
Procedure without PG/PC
Requirements
● Install the IO_LINK_DEVICEfunction block.
You can download the IO_LINK_DEVICE function block and the description from the
Internet (https://support.industry.siemens.com/cs/ww/en/view/82981502).
On completion of commissioning, a PG/PC with the project is no longer available. For
backing up and restoring the parameter data and configuration data from or to a module, the
IO_LINK_DEVICE function block is available for the SIMATIC controllers of the S7 family.
With this function block, you back up all relevant data records of a module after
commissioning, in a data block (DB), for example. In the event of a replacement, write the
relevant data from the data block to the replaced module with the IO_LINK_DEVICE function
block.
Refer to the Appendix "Process data and data sets (Page 575)" for data records to be
backed up in the case of a module.
Procedure
1. Copy the IO_LINK_DEVICE function block (including data block DB10) to a STEP 7
project.
2. Use the IO_LINK_DEVICE function block as described in the documentation.
3. You will find an application example of how to use the IO-Link devices with the
IO_LINK_DEVICE function block on the Internet
(http://support.automation.siemens.com/WW/view/en/90529409).
Note
An IO-Link device is a module that communicates with the IO-Link master via its
communication connection.
310
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010