Front Plate Mounting For Enclosure Mounting - Siemens SIRIUS ACT 3SU1 System Manual

7.2.2

Front plate mounting for enclosure mounting

Requirement
The enclosure cover has been removed.
You need at least the following elements in order to construct a command point:
● An actuating or signaling element (3SU12) in front of the enclosure cover.
● A holder (3SU15) behind the enclosure cover.
Procedure
1. Insert the actuating or signaling element from the front through the cut-out in the
enclosure cover.
2. Fit the holder from behind (wiring side) onto the actuating or signaling element and latch it
into place.
The unit must be aligned before it is finally tightened and locked against twisting. For
information, please refer to Chapter "Aligning (Page 117)").
3. Turn the screw at the holder until the actuating or signaling element is fixed securely and
cannot vibrate or twist (tightening torque 1.0 ... 1.2 Nm).
Wire the actuating or signaling element.
Fit the enclosure cover back into position.
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
3SU12 compact units
7.2 Mounting
161