Mx460B-R Frequency / Counter Module - HBM SomatXR CX23-R User Manual

Transducer
Frequency / pulse counter
(timer, TTL)
Incremental encoder
(timer, TTL)
Torque / speed
Passive inductive encoder
PWM - Pulse width, pulse duration, period duration
Crank wheel sensors
CX23-R and EX23-R
NOTE
Connection between pins 4 and 5 is necessary for all transducers. Note that the
sensor connector must have a connection between pins 1 and 11 for
compatibility with the MX1615B-R module.
5.3.6 MX460B-R Frequency / Counter Module
Up to four (4) digital inputs may be connected to the MX460B-R, to measure digital
pulses up to 1 MHz (speed, torque, angle position, displacement, PWM in general).
CX23-R/eDAQXR support is limited in the following aspects. Math functions are not
supported. Interactive zeroing of the "crank shaft" sensors is not supported.
You can connect up to four transducers to the frequency measuring amplifier
MX460B-R. Transducers are connected via a 14‐ pin ODU device socket. All
measuring channels are electrically isolated from one another and from the mains.
When using the adjustable transducer excitation, electrical isolation from the supply
voltage of the amplifier is not required.
The MX460B can supply transducer excitation voltage at a constant DC voltage of 5
to 24 volts. Always check encoder data sheet for maximum supply voltage.
Supplying 12-volt transducer power to a 5-volt encoder may damage it.
The measurement channels are electrically isolated from the power supply and the
interfaces. When TEDS or T-ID is used, the measurement channel is automatically
parameterized after connection.
Status LED
a4275-8.0 en HBM: public
5 SomatXR hardware
MX460B-R Wiring diagram
●
117
●
117
●
117
●
123
●
123
●
131
95