List: Output States - Siemens MXL-IQ Operation, Installation, And Maintenance Manual

The System displays the CSG-M assigned
System custom message:
MSG [system custom message]
Press NEXT again to display the MXL-IQ
software version:
MXL-IQ VERSION: [version number]
Press NEXT again to display the version of
CSG-M used to create this System.
CSG VERSION: [version number]
Press NEXT again to display the CSG-M
file name installed.
SOURCE: [file name]
Press NEXT again to display the date and
time of CSG-M installation:
LOADED: [time and date]
Print the Software Version of Your System
Software
Press PRINT when the S in SW_ VER-
SION is blinking to select List S/
W_Version. The System prints the System
Custom Message, MXL-IQ Software
Version, Version of CSG-M Used to Create
the System, CSG-M File Name Installed,
and Date and Time of Installation:
Software Version Information at
11:35:30 Jul 01, 20XX
Installation: [system custom message]
MXL-IQ Version: 1.00
CSG Version: 6.09
Source: 05OCT00
Loaded: 16:09:35 Oct 05, 20XX
(To end a menu session and return to the
Main Menu or to leave the menu at any time,
press the Up arrow key to go backward one
menu each time.)

List: Output States

Use List Output States to show the current
states of individual outputs in the MXL-IQ.
From the List menu use the left or right
arrow key to cause the O in Output States
to start blinking:
LIST: OUTPUT STATES
(If you press HELP at this point, the System
displays:
SHOW/PRINT OUTPUT STATES
Press HELP again to return to the List menu.)
Display the Output States of One Device
Press ENTER to select List Output States.
The System asks you for a module and
device number.
TYPE IN MODULE & DEVICE: 001-001
Type the three-digit module number and
three-digit device number using the nu-
meric keypad and press ENTER. (Enter all
leading zeros.)
The System displays the output state of the
device specified.
Press NEXT to display the address and
output state of each succeeding device.
When the System has shown the output
states of all devices at that address, it
returns to the List menu.
To leave the List output state menu without
going through all subaddresses, press the
Up arrow key. The System displays the List
menu.
Print the Device Output State of Devices
Assigned to a Specified Module
Press PRINT when the O in Output States
is blinking. The System then asks for a
module number.
TYPE IN MODULE NUMBER: [module number]
Type the three-digit module number and
press ENTER. (Enter all leading zeros.)
The System prints the output state of all of
the devices assigned to that module.
Operation
3-31