General Guidelines For Installing The Mxl-Iq - Siemens MXL-IQ Operation, Installation, And Maintenance Manual

I I I I I nst nst nst allat allat
nst allat allat ion
nst allat
Remove all system power before
installation, first battery and then AC.
This section provides general installation
instructions for mounting, wiring, and
checkout of the MXL-IQ Control System
from Siemens Industry, Inc.
Read this section before installing the
equipment to ensure proper installation. If
you are not familiar with the MXL-IQ, also
read the first section of the manual. Be sure
to ask Siemens Industry, Inc. Technical
Support or an authorized Representative if
you have any questions.
Install and use the MXL-IQ System in
accordance with the appropriate Local,
NFPA, and NEC Code requirements.
WARNING!
Refer to the last page of the
manual for a Warning Note
required by the FCC for all
commercial Class A computing
equipment producing a clock
frequency of 10K Hz or greater.
ion ion
ion
ion
General Guidelines For Installing The
MXL-IQ
Always remove power (battery and AC)
and wait at least 10 seconds to allow the
supply voltages to decay before installing
or removing any module, cable, or wiring.
NOTE:
Follow Steps 1 through 13 for installation.
Each step is thoroughly explained in the
following pages.
1. Install the enclosure (page 2-2).
2. Install the TSW-2 Tamper Switch
where required (page 2-2).
3. Pull the field wiring into the backbox
and dress it to approximately where it
will go (page 2-3).
4. Install the SMB-2 (page 2-3).
5. Install the MPS-6 (page 2-3).
6. Install the MKB-4 (page 2-4).
7. Install the PIM-1, PIM-2, and PAL-1 (If
applicable) (page 2-5).
8. Install the MOM-2 or MOM-4 card
(page 2-6).
9. Install the MOI-7, MOD-16, and
MID-16 (If applicable) (page 2-9).
10. Install Field Wiring (page 2-10).
11. Check Field Wiring (page 2-10).
12. Start-up Procedure (page 2-10).
13. System Function Checkout (page 2-16).
If available, use a printer during
the installation procedure as a
debugging tool.
2 2 2 2 2
Chapter
INTRODUCTION
2-1