Table of Contents
Advertisement
Description
Figure 11
ALD-2I Analog Loop Driver
Figure 12
CMI-300 Interface Module
Figure 13
CPY-HLI Interface Card
1-8
RS-232 Port
CPY-HLI
V'Net Port A
Shield
V'net B
-
+
Shield
V'net A
-
+
VESDAnet
-
-
+
+
DC Power
OPTIONAL
The following modules are available as
MODULES
options to the MXL-IQ Control Panel:
NOTE: Modules marked with an asterisk (*) do
not mount in the MSE-3L enclosure.
ALD-2I Analog Loop Driver
The ALD-2I Analog Loop Driver provides two
initiating device circuits capable of Class A
or Class B operation for monitoring analog
devices. Each loop is capable of monitoring
up to 60 analog devices. Each device has
its own address. You can use CSG-M to
write a custom message for each device
(See CSG-M Programming Manual, P/N
315-090381).
CCU/M Pager Interface Module
The CCU/M alphanumeric interface module
connects to any MXL System and can be
programmed to send selected information
to specific pagers programmed into the
CCU/M. This equipment is designed to be
installed and serviced by fully qualified field
engineers. There are no user-serviceable
or installation parts inside the unit.
CMI-300 Interface Module
The CMI-300 provides modem communica-
tions between an MXL-IQ System and a CXL
System. The CMI-300 module is located on
the MOM-2/4 board in the MXL-IQ enclo-
sure. The CMI-300 plugs into a half slot in
the MOM-2/4. It translates signals from the
MXL-IQ communication lines of the SMB-2
to CXL modem signals. This signal is then
transmitted along suitable cable to the CXM-1
module in the CXL enclosure.
CPY-HLI Interface Card*
The CPY-HLI interfaces MXL-IQ to VESDA
detectors. MXL-IQ requires a NIM-1W
module configured in CSG-M as an Air
Sampling (VESDA) interface.
• The interface gives the MXL-IQ the
ability to list, control, and annunciate
the state of up to 31 VESDA detectors
connected to a single NIM-1W.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
