Supervisories; How The System Annunciates Supervisories; Viewing The List Of Supervisories; How To Block Acknowledge A Supervisory - Siemens MXL-IQ Operation, Installation, And Maintenance Manual

Operation
SIL alternately silences and unsilences the
System.)
If your System has a printer, it prints a
message similar to the following:
AUD SILENCED/UNSIL. 11:01:00 DEC 31, 20XX
AUDIBLES SILENCED

Supervisories

How The System Annunciates
Supervisories
When a supervisory is detected, the
System causes the SUPERVISORY LED
on the MKB-4 to flash, the System's
internal audible to sound, and the alphanu-
meric display on the MKB-4 to alternate in a
sequence among the three messages
shown below. This example assumes that
two supervisories were received (See the
explanations below).
Message 1:
1-001 [custom message]
002 [device type] IN SUP
Message 2:
1-001 [custom message]
002 [time/date] IN SUP
Message 3:
ALARMS=000
SECURITIES=000
In addition, the System responds to
supervisories with programmed output
functions such as other audible signals.
In the messages above, 1-001 represents
the address of the device reporting the
supervisory.
002 in the first message tells you that this is
the second (and the most recent) of two
supervisories received.
The status information in the third message
reports the total of alarms, supervisories,
troubles, and security conditions.
3-8
SUPERVISORIES=002
TROUBLES=000
If your System includes a printer, it prints a
message from two to four lines long similar
to the following:
SUPERV 1-1 11:59:59 DEC 31, 20XX
#1 [custom message], [device type]
In the preceding message, SUPERV
indicates that the type of occurrence is a
supervisory; 1-1 is the device address; #1
is the number of the supervisory in the list
of supervisories; [custom message] is a
custom message entered using the CSG-M
Custom Software Generator (See the CSG-M
Programming Manual, P/N 315-090381);
[device type] is the type of device which
reported the supervisory.

Viewing the List of Supervisories

To see the supervisory list when there is
more than one supervisory, press NEXT on
the MKB-4 (the System displays the most
recent supervisory first).
How to Block Acknowledge a
Supervisory (NFPA 72 Local, Municipal
Tie, and Remote Station)
1. Note the specific location of the
supervisories by using the procedures
described above.
2. Unlock and open the door.
3. Press SUPV ACK to acknowledge all
supervisories. The System displays the
following message:
ALL SUPERVISORIES ACKNOWLEDGED.
4. If your System includes a printer, it prints
the following message:
ACK SUPERVISORY 11:59:59 DEC 31,20XX
ALL SUPERVISORIES ACKNOWLEDGED
5. If you press SUPV ACK again, the
System displays ALL SUPERVISORIES
ACKNOWLEDGED.
The SUPERVISORY LED glows steadily
to indicate that all supervisories are
acknowledged. If there are no troubles or
security conditions in the System, the
internal audible goes silent; if any of
those conditions still exist, the internal
audible pulses.