Polycom Trio 8800 User Manual page 61

device.wifi.radio.band2_4GHz.enable.set="1"
device.wifi.radio.band2_4GHz.enable="1"
device.wifi.radio.band5GHz.enable.set="1"
device.wifi.radio.band5GHz.enable="1"
device.wifi.enabled.set="1"
device.wifi.enabled="0"
device.net.enabled.set="1"
device.net.enabled="1"
The WLAN operating mode on the Polycom Trio 8800 system is mutually exclusive of the Wireless
Display feature. You can enable Wireless Display only if wired Ethernet is used for calling and
conferencing. Ensure that wired Ethernet is used for calling and conferencing by configuring the
following:
Video Quality is Poor
Incorrect image resolution can cause content delays and video artifacts. Note that the Polycom Trio 8800
system does not accept 1080@60fps video resolution.
● To resolve video quality issues, configure the following for the Polycom Trio 8800 system:
content.wirelessDisplay.sink.width="0"
content.wirelessDisplay.sink.height="0"
content.wirelessDisplay.sink.fps="0"
● In addition, you can set a limit on the live stream parameters by setting:
content.wirelessDisplay.sink.fps="30"
Configuring Debugging Logs
If you experience further issues using Wireless Display on the Polycom Trio 8800 system, you can enable
the following logging parameters on your Polycom Trio 8800 system to get extended debugging data.
Wireless Display Debugging Parameters
Parameters
wdisp
apps
lc
Access Diagnostic Information
If you experience issues using Wireless Display on the Polycom Trio 8800 system, you can access
diagnostic information from the Polycom Trio 8800 menu.
Polycom, Inc.
Permitted Values
Wireless Display session management and communication with the Wireless Display
source
Wireless Display support for Android
Local Content (including Wireless Display and PPCIP) session management
Content
61