Polycom Trio 8800 User Manual page 52

Content Sharing Parameters
Parameter
Template
content.autoAccept.rdp
new.cfg
content.bfcp.enabled
new.cfg
content.bfcp.port
sip-interop.cfg
content.bfcp.transport
features.cfg
content.ppcipServer.enabled
new.cfg
content.ppcipServer.meeting
Password
site.cfg
smartPairing.mode
features.cfg
smartPairing.volume
features.cfg
Polycom People+Content IP over USB
You can use Polycom ®
computer connected by USB to the Polycom Trio system when in or out of a call. When you install PPCIP
version 1.4.2 and run it unopened in the background, the PPCIP application pops up immediately when you
connect the computer to Polycom Trio solution via USB.
Keep the following points in mind:
● Showing content with People+Content IP over USB provides content to a maximum of 1080p
resolution on a connected Windows or Mac computer.
● Audio content is not shared.
Polycom, Inc.
Permitted Values
1 (default) - Content shown by far-end users is automatically accepted and
displayed on the Polycom Trio solution.
0 - Near-end users are prompted to accept meeting content sent to
Polycom Trio solution from a far-end user.
1 (default) - Enable content sharing by offering or accepting the Binary
Floor Control Protocol (BFCP) in Session Description Protocol (SDP)
negotiation during SIP calls. Does not apply to Skype for Business calls.
0 - Disable content sharing using BFCP.
15000 (default) -
0 - 65535 -
UDP (default) -
TCP -
1 (default) - Enable Polycom People+Content IP.
0 - Disable Polycom People+Content IP.
NULL (default) -
String (0 - 256 characters) -
Enables users with People+Content IP or Polycom Desktop on a computer
or Polycom Mobile on a tablet to pair with the Polycom Trio conference
phone using SmartPairing.
Disabled (default) - Users cannot use SmartPairing to pair with the
conference phone.
Manual - Users must enter the IP address of the conference phone to pair
with it.
The relative volume to use for the SmartPairing ultrasonic beacon.
6 (default)
0 - 10
People+Content ® IP (PPCIP) to share video or data from a Windows
Content
® or Mac ®
52