Polycom Trio 8800 User Manual page 101

Dial Plan, Dial Plan Normalization, and Digit Map Parameters
Template Parameter
site.cfg dialplan.1.lyn
cDigitmap.time
Out
site.cfg dialplan.userD
ial.timeOut
Polycom, Inc.
Permitted Values
This parameter applies to lines
registered with Skype for
Business or Lync Server.
Specify a timeout in seconds for
each segment of a digit map.
After you press a key, the phone
waits the number of seconds you
specify to match the digits to a
dial plan and dial the call.
4 seconds (default)
0 to 99 seconds
Note: If there are more digit maps
than timeout values, the default
value is used. If there are more
timeout values than digit maps,
the extra timeout values are
ignored.
Note also that if you configure a
value outside of the permitted
range, the default value is used.
1 Changes to the value of this
parameter cause the phone to
restart.
Specify the time in seconds that
the phone waits before dialing a
number you enter while the
phone is on hook. This parameter
applies only when its value is
lower than up.IdleTimeOut.
4 seconds (default)
0 to 99 seconds
Call Controls
Change Causes Restart or
Reboot
No
No
101