Polycom Trio 8800 User Manual page 36

Video and Camera Parameters
Template Parameter
reg-advanced.c reg.x.fecc.enabled
fg
features.cfg up.arrow.repeatDelay
features.cfg up.arrow.repeatRate
video.cfg video.camera.autoWhit
eBalance
video.cfg video.camera.backligh
tCompensation
video.cfg video.camera.brightne
ss
video.cfg video.camera.contrast
features.cfg video.camera.controlS
tyle
Polycom, Inc.
Permitted Values
1 (default) - Enable far-end camera
control for the line you specify with x.
0 - Disable far-end camera control for
the line.
Choose the milliseconds (ms) an
arrow button must be held before the
arrow starts repeating in the Camera
Controls menu for Polycom EagleEye
IV USB camera.
500 ms (default)
100 – 5000 ms
Choose the milliseconds (ms) between
repeated simulated presses while an
arrow button is being held down. This
applies to the arrows in the Camera
Controls menu for Polycom EagleEye
IV USB camera.
80 ms (default)
50 – 2000 ms
0 – Auto white balance is disabled.
1– Auto white balance is enabled and
the value.
0 – Disable backlight compensation.
1 - Enable backlight compensation.
Sets the brightness level of the video
stream. The value range is from 0
(dimmest) to 1000 (brightest).
NULL (default)
0 - 1000
Sets the contrast level of the video
stream for all supported USB cameras.
The value range is from 0 (no contrast
increase) to 3 (most contrast
increase), and 4 (noise reduction
contrast).
NULL (default)
0 - 1000
Controls whether Polycom EagleEye
IV USB camera pan and tilt is
controlled by directional arrow buttons
or separate pan/tilt sliders.
Simple (default)
Video Features
Change Causes
Restart or Reboot
No
No
No
No
No
No
No
No
36