Polycom Trio 8800 User Manual page 150

Note: You cannot use Polycom Trio Visual+ for video calls when you connect the Polycom Trio 8800
system to your network using Wi-Fi. The Polycom Trio 8800 system and Polycom Trio Visual+ pair
only when the Polycom Trio system is connected to your network over Ethernet.
Pair the Polycom Trio System Manually
You can manually pair the Polycom Visual+ to the Polycom Trio system from the Polycom Trio system menu.
To pair Polycom Trio Visual+ with Polycom Trio system manually:
1 Set up Polycom Trio Visual+. For instructions, refer to the Polycom Trio system Setup Sheet.
The Welcome screen displays on your monitor and indicates steps to pair with the Polycom Trio
system.
2 Tap the Pair button on Polycom Trio Visual+ to broadcast discovery to the Polycom Trio.
3 On the Polycom Trio system, go to Settings > Advanced > Networked Devices, and ensure that
Notification of New Devices is On.
4 Choose one of the following:
 If you have not paired the device before, tap Pair with New Device, tap the device you want to
pair from the Discovered Devices list, and in the Details screen, tap Pair. (All currently paired
devices display under Paired Devices.)
 If the device has been paired before, select the device from the Available Devices list and tap
Pair.
5 When you see the message prompting you to complete pairing, do one of the following:
 Tap Complete.
 Tap the Pair button on the Polycom Visual+
If pairing was successful, a success message displays on the monitor along with a self-view window,
the LED light on the Polycom Trio Visual+ device is continuously green, and a paired icon displays
on the phone.
If pairing was not successful, a message displays on the monitor that the devices could not pair.
After successful pairing, if devices become disconnected for 60 seconds, a message displays that
the devices have temporarily lost connection.
Polycom Trio System Pairing Parameters
To pair using configuration files, enter the MAC address of your Polycom Visual+ as the value for the
parameter mr.pair.uid.1. The MAC address can be in either of the following formats:
● 00e0d::B09128D
● 00E0DB09128D
Use the following parameters to configure this feature and additional feature options.
Polycom, Inc.
Hardware and Accessories
150