Extended Link Layer Discovery Protocol (Lldp) - Polycom Trio 8800 User Manual

Configure Wi-Fi Network Parameters
Parameter Function
Enable the Wi-Fi radio.
Enter the two-letter code for the country in which you
enable the Wi-Fi radio.
Enable DHCP for Wi-Fi.
The IP address of the wireless device if not using
DHCP.
The network mask address of the wireless device if not
using DHCP.
The IP gateway address of the wireless device if not
using DHCP.
The SSID of the wireless network.
Specify the wireless security mode.
The length of the hexadecimal WEP key.
The hexadecimal key or ASCII passphrase.
The EAP to use for 802.1X authentication.
The WPA2-Enterprise user name.
The WPA2-Enterprise password.

Extended Link Layer Discovery Protocol (LLDP)

The Link Layer Discovery Protocol (LLDP) is used by network devices to advertise their identity, capabilities,
and neighbors on an IEEE 802 local area network, principally wired Ethernet. LLDP is enabled by default.
Media Endpoint Discover (MED) capabilities include:
● Network policy discover
● Endpoint location identification discovery
● Extender power discovery required for endpoint
Configuring LLDP Fast Start Count
Fast start count enables a device to initially advertise itself over the network at a fast rate for a limited time
when an LLDP-MED endpoint has been newly detected or connected to the network.
Polycom, Inc.
template > parameter
device.wifi.enabled
device.wifi.country
device.wifi.dhcpEnabled
device.wifi.dhcpBootServer
device.wifi.ipAddress
device.wifi.subnetMask
device.wifi.ipGateway
device.wifi.ssid
device.wifi.securityMode
device.wifi.wep.key
device.wifi.psk.key
device.wifi.wpa2Ent.method
device.wifi.wpa2Ent.user
device.wifi.wpa2Ent.password
device.wifi.radio.enable2ghz
device.wifi.radio.enable5ghz
Network
125