Siemens SINAMICS G120D Operating Instructions Manual page 275

Display options
In this area, you can set how the measurement results are displayed.
● Repeating measurements
● Arrange the curves in tracks
● Measuring cursor on
Figure A-2 Trace dialog box
Converter with control units CU240D-2
Operating Instructions, 04/2014, FW V4.7, A5E34262100B AA
This places the measurements that you wish to perform at different times above one
other.
This means you define whether the trace of all measured values is displayed with respect
to a common zero line – or to separate zero lines.
This allows you to analyze the measuring intervals in more detail.
Appendix
A.4 Handling STARTER
275