Debug Qos-Manager - Cisco Catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug qos-manager

Use the debug qos-manager privileged EXEC command to enable debugging of the quality of service
(QoS) manager software. Use the no form of this command to disable debugging output.
Syntax Description
all
event
verbose
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug qos-manager command is the same as the no debug qos-manager command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands Command
show debugging
78-16181-01
debug qos-manager {all | event | verbose}
no debug qos-manager {all | event | verbose}
Display all QoS-manager debug messages.
Display QoS-manager related-event debug messages.
Display QoS-manager detailed debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, refer to the Cisco IOS Release 12.2 Configuration
Guides and Command References > Cisco IOS Configuration
Fundamentals Configuration Guide, Release 12.2 > System Management
> Troubleshooting and Fault Management.
Catalyst 3750 Switch Command Reference
debug qos-manager
B-65