Effects; Effects Screen - Roland MV-8000 Owner's Manual

EFFECTS

Here you can make settings for the built-in MFX (multi-effect), delay/chorus,
and reverb.

EFFECTS screen

In this effects screen you can check the state of the
multi-effect, delay/chorus, and reverb.
Explanation of each area
1. Cursor
The effect section (MFX, delay/chorus, reverb) at
which the cursor is located is highlighted. The
highlighted effect section is called the "current
effect."
2. Effect section
Indicates the type of effect.
Display
MFX
Dly/Cho
Reverb
3. Algorithm icon
The effect algorithm used by each effect section is
indicated by the icon shown.
4. Routing
Specifies where the MFX will be placed within the
mixer.
Display
Off
Input
AUX1~4
Master
You can select the Routing parameter only for MFX.
5. Control parameter
Indicates the names of the parameters controlled by
the control knobs. Three parameters are displayed;
372
Explanation
Multi-effect
Delay/Chorus
Reverb
Explanation
MFX is not used.
Input bus
AUX 1~4 bus
Master out bus
To access this screen
•
from the left they correspond to the C1, C2, and C3
knobs.
6. Control knobs
Use these knobs to control major parameters of the
effect algorithm used by each effect section.
There are three knobs for each section; they
correspond to knobs C1~C3 of the top panel.
To operate these knobs, use the
(up/down) cursor keys to move the highlighted
area to the appropriate effect section.
The Knob Assign function (p. 377) lets you freely
assign an effect parameter to each knob.
7. Effect patch name
Indicates the name of the effects patch.
8. Effect Algorithm
Indicates the name of the algorithm used by each
effect.
9. Effect switch
Switches the status of each effect section.
Status Explanation
Off The effect is not used.
On The effect is enabled.