Roland MV-8000 Owner's Manual page 61

To change the Loop Mode of a sample
1. Perform the steps described in Accessing the Sample Edit screen (p. 60).
The SAMPLE EDIT screen (p. 279) will appear.
2. Use the SMT parameter to select the sample
whose loop mode you want to change.
3.
Edit the Loop Mode parameter.
The sample will play between the specified Loop
Point and the End Point according to the loop mode
you select. For details on this parameter refer to the
SAMPLE EDIT screen (p. 279).
To emphasize or reduce the high-frequencies of the sample
(Emphasis)
In some cases, boosting the high-frequency range of an imported sample will improve
the audio quality. Alternatively, a sample may have an excessively strong
high-frequency range when it is played by a sampler made by another company, and
in such cases you can minimize such change by de-emphasizing the high-frequency
range.
1.
Perform the steps described in To specify the playback region of a sample
(p. 60).
The Emphasis operation will apply to the region between the Start Point and End Point
of the sample.
2. Press (Command).
The SELECT SAMPLE EDIT COMMAND popup
(p. 283) will appear.
3. Move the cursor to Emphasis and press
.
The EMPHASIS screen (p. 284) will appear.
4. Set the Emphasis Type parameter.
Select either Pre Emphasis (boost the high
frequencies) or De Emphasis (reduce the high
frequencies).
5. Press (Execute).
The Emphasis operation will be executed.
To maximize the level of a sample (Normalize)
This operation raises the level of a sample as high as possible without allowing it to
exceed the maximum possible level.
1. Perform the steps described in To specify the playback region of a sample
(p. 60).
The Normalize operation will apply to the region between the Start Point and End
Point of the sample.
2.
Press (Command).
The SELECT SAMPLE EDIT COMMAND popup (p. 283) will appear.
3. Move the cursor to Normalize and press
Editing a sampled sound
.
61