Roland MV-8000 Owner's Manual page 278

INSTRUMENTS
22. LFO (Low Frequency Oscillator type)
Selects the waveform that the LFO will output.
Value Explanation
Sine wave
Sine
Tri Triangle wave
SawU Sawtooth wave
SawD Sawtooth wave (inverted)
Squr Square wave
Rand Random wave
The LFO will output a waveform
BenU that rises to the normal level and
stays there
The LFO will output a waveform
BenD that falls to the normal level and
stays there
If you select "Bend Up" or "Bend Down," you must
set the Key Sync parameter (PARTIAL EDIT (LFO)
screen (p. 296)) to "On." If this is "Off," the LFO
effect will not be obtained.
23. LFO Rate
Specifies the rate (frequency) of the waveform
produced by the LFO.
Range: 0~102~127,
,
24. LFO Depth Pitch
Specifies the amount by which the LFO will affect the
pitch.
Range: -63~0~+63
25. LFO Depth Pan
Specifies the amount by which the LFO will affect the
panning.
Range: -63~0~+63
26. LFO Depth Filter
Specifies the amount by which the LFO will affect the
filter.
Range: -63~0~+63
27. LFO Depth Amp (LFO Depth Amplifier)
Specifies the amount by which the LFO will affect the
volume.
Range: -63~0~+63
278
, , , , , ,
, , , , , , , , ,
F-buttons and menu
Sample Edit
Displays the SAMPLE EDIT screen (p. 279).
SMT (Sample Mix Table)
Displays the PARTIAL EDIT (SMT) screen (p. 289).
Filter
Displays the PARTIAL EDIT (FILTER) screen (p.
291).
Amplifier
Displays the PARTIAL EDIT (AMPLIFIER) screen
(p. 294).
LFO (Low Frequency Oscillator)
Displays the PARTIAL EDIT (LFO) screen (p. 296).
Menu
, ,
Displays the PARTIAL EDIT MENU.
, , ,
Menu items
1. Partial Name
Displays the EDIT NAME popup (p. 199), where you
can edit the name of the current partial.
The PARTIAL EDIT MENU will also appear when
you press [MENU] in the following screens.
• PARTIAL EDIT (SMT) screen (p. 289)
• PARTIAL EDIT (FILTER) screen (p. 291)
• PARTIAL EDIT (AMPLIFIER) screen (p. 294)
• PARTIAL EDIT (LFO) screen (p. 296)