Exchanging The Memory (Removing And Installing) - Roland MV-8000 Owner's Manual

Adding options
Exchanging the memory (removing and
installing)
1.
Turn off the power of the MV-8000 and the connected devices, and
disconnect all cables from the MV-8000.
2.
Turn the MV-8000 upside down, and lay it on its face supported by objects at
each corner so that the panel buttons and knobs are not damaged.
3.
Remove sixteen screws from
the bottom panel at the
locations shown in the
illustration, and detach the
bottom cover.
4. Simultaneously spread apart the two
white clips located at both ends of the
DIMM socket.
5. Pull the (old) memory module out of
the socket.
6. Make sure that the cutouts in the
(new) memory module are positioned
correctly, and press it directly
downward into the guide slots.
7.
Continue pressing until the white clips
pop upward into position, locking the
memory module into place.
8. Replace the bottom cover as it was
originally.
9. Turn on the power.
Please wait until the MV-8000 has finished
starting up.
If an unsupported type of memory (DIMM) is installed, a message of "Wrong DIMM
Type! Turn off the power, and replace w/correct one" will appear when you
power-on, and the MV-8000 will not operate.
10.
Checking the installed memory as described in Testing the installed
memory (Memory Diagnosis) (p. 184).
186
15
14
16
1
2
8
3
4
7
5 6
When you lay the MV-8000 on
its face, make stacks of
magazines or newspapers to
13 support each of the four
corners so that the weight of
12
the unit does not damage the
11
buttons and knobs. Make sure
10
9
that no pressure is being
applied to any button or knob.
If you have difficulty inserting
the memory module, you can
angle the module slightly,
alternately pressing on either
end to insert it little by little.
If no memory is installed, the
display will indicate "No
Wave Memory (DIMM)."
Please install memory as
described in Exchanging the
memory (removing and
installing) (p. 186).