Tone Part Effects' Parameters - Roland BK-7m Owner's Manual

Backing Module BK-7m
Menu options
Vibrato Delay
This parameter adjusts the time required for the
vibrato effect to begin. Positive (+) settings increase
the time before vibrato will begin and negative set-
tings shorten the time.
Parameter
Vibrato Delay
C1
The function of this parameter depends on the sound
you assigned to the selected part. It may influence
the filter and Resonance setting, switch between the
organ samples with the fast and slow Rotary modu-
lation, etc.
Parameter
C1
Key Range Lower, Key Range Upper
The "Key Range Lower" and "Key Range Upper"
parameters allow you to set the note range to be
received for the selected part.
Parameter
Key Range Lower
Key Range Upper
NOTE
The "Upper Range Lower" value cannot be higher than or
equal to "Key Range Upper" (and vice versa).
54
Setting
–64~+63
Setting
0~127
Setting
C1~G9
C1~G9

'Tone Part Effects' parameters

This function group can be selected using [MENU] but-
ton ‰ "Performance Edit" ‰ "Tone Part Effects".
1.
Use the [CURSOR÷VALUE] dial to select and
set the desired effects processor (Mfx,
Reverb, Chorus).
The display shows the settings for the selected real-
time part.
The following parameters are available:
a) Mfx parameters
This function group can be selected using [MENU]
button ‰ "Performance Edit" ‰ "Tone Part Effects" ‰
"Mfx".
Your BK-7m contains a multi-effects processor that
can be used for processing any real-time part you
like. See "Mfx" on p. 52. (There are also 3 Mfx proces-
sors for the Style/Song parts.)
Mfx Switch
Select "Off" if you don't need the Mfx processor.
Parameter Setting
Mfx Switch Off, On