Roland MV-8000 Owner's Manual page 349

Explanation of each area (Mixer)
This adjusts the volume of each frequency band.
1. Block name (Output Mixer)
Displays the parameters of the mixer block.
2. Level
Adjust the level of each frequency band
(Low/Mid/High) after it passes through the
expander and compressor.
Range: -80~+6 dB for each band
Explanation of each area (Limiter)
This reduces high input levels to keep the signal from
distorting.
1. Block name (Limiter)
Displays the limiter parameters.
2. Switch
Switches the limiter block on/off.
If you press [F5 (Sw On/Off)], turn effect block
switch on/off.
Range: Off, On
3. Threshold
Specifies the volume at which the limiter begins to
apply.
Range: -24~0 dB
4. Attack
Specifies the time from when the input level exceeds
the value of the Threshold parameter until the limiter
begins to apply.
Range: 0~100 ms
5. Release
Specifies the time from when the input level falls
below the value of the Threshold parameter until the
limiter no longer applies.
Range: 50~5000 ms
MASTERING
349