Mv8-Vga Installation Procedure - Roland MV-8000 Owner's Manual

Adding options

MV8-VGA installation procedure

1.
Turn off the power of the MV-8000 and the connected devices, and
disconnect all cables from the MV-8000.
2.
Remove two screws from the
MV8-VGA installation slot
cover as shown in the
illustration.
3. Remove the slot cover, and
pull out the cable that is
fastened behind the slot cover.
4. Plug this cable into the
connector of the MV8-VGA.
Align the red wire of the cable
(at the right edge in the
illustration) with the ▲ mark of
the connector, and plug the
cable firmly into the connector.
5.
Insert the MV8-VGA into the
slot, oriented as shown in the
illustration.
6. Use the two screws to fasten
the MV8-VGA.
190
▲ mark
red
Be careful not to cut your
hand on any sharp edges of
the installation slot, cover,
or circuit board.