Roland MV-8000 Owner's Manual page 295

8. Envelope Velo Sens T1 (A) (Envelope Velocity
Sensitivity Attack Time)
Specifies how velocity will affect T1 of the amplifier
envelope (see the Amplifier Envelope diagram). Use
positive (+) settings if you want T1 to be faster for
stronger velocities, or negative (-) settings if you want
it to be slower.
Range: -63~0~+63
9. Envelope Velo Sens T4 (R) (Envelope Velocity
Sensitivity Release Time)
Specifies how velocity will affect T4 of the amplifier
envelope (see the Amplifier Envelope diagram). Use
positive (+) settings if you want T4 to be faster for
higher note-off velocities (i.e., releasing the key more
quickly), or negative (-) settings if you want it to be
slower.
Range: -63~0~+63
10. Envelope T1 (A), T2 , T3(D), T4 (R) (Envelope Times
1~4)
These specify the amplifier envelope times (T1~T4).
Higher values lengthen the time until the next level is
reached (e.g., T2 sets the time of the change from L1
to L2).
Range:
0~127
11. Envelope L1, L2, L3 (S) (Envelope Levels 1~3)
These specify the amplifier envelope levels (L1~L3).
Each parameter specifies the change in level relative
to the setting of the Level parameter in the PARTIAL
EDIT (SMT) screen (p. 289).
Range:
0~127
Volume
T1 T2 T3
L1 L2
Key-on
T: Time, L: Level
Amplifier envelope
T4
Time
L3
Key-off
F-buttons
Sample Edit
Displays the SAMPLE EDIT screen (p. 279).
SMT (Sample Mix Table)
Displays the PARTIAL EDIT (SMT) screen (p. 289).
Filter
Displays the PARTIAL EDIT (FILTER) screen (p.
291).
LFO (Low Frequency Oscillator)
Displays the PARTIAL EDIT (LFO) screen (p. 296).
INSTRUMENTS
295