Editing A Partial; Selecting The Partial You Want To Edit - Roland MV-8000 Owner's Manual

Editing a sampled sound

Editing a partial

You can modify the sound by editing each "partial" of which the patch consists.

Selecting the partial you want to edit

1.
Access the PATCH EDIT screen as described in Accessing the Patch Edit
screen (p. 51).
2. Press (Partial Edit).
The PARTIAL EDIT screen (p. 276) will appear.
3.
Use the partial number in the upper left of the screen to select the partial you
want to edit.
Selects
the output destination
of the partial.
Specifies
the volume
and pan.
Specifies
the filter settings.
There will appear the message "Partial does not exist. Do you want to create it with Sample?" if
no partial is assigned to the pad (note number) you strike is assigned.
F-button Explanation
Cancels the operation.
(No)
When you select a sample, the partial will be assigned to that pad,
(Yes)
and you will return to the PARTIAL EDIT screen (p. 276).
To adjust the volume or pan
➜
adjust the Level or Pan parameters.
The volume is set by the General parameter Level, and the pan is adjusted by the
General parameter Pan.
To change the audio output destination of the partial
➜
change the Output Assign setting.
For details on this parameter refer to PARTIAL EDIT screen (p. 276).
To use an effect (delay/chorus, reverb)
➜
adjust the DlyCho Send parameter or the Reverb Send parameter.
Raise the DlyCho Send parameter to apply delay/chorus, or raise the Reverb Send
parameter to apply reverb.
56
Specifies what will happen
when the same partial
is played.
Specifies the amount
the identical note number
of sound sent
is played twice.
to the loop effects.
Specifies a partial assigned
to the same exclusive group number
are played simultaneously.
Specifies
Adjusts the pitch.
Adjusts
the pitch modulation.
Specifies
how the volume
will change.
"partial" is one of the sounds
of which the patch consists.
Each partial consists of a
sample together with various
parameters to modify its
sound, and is assigned to one
or more note numbers.
In the SEQUENCE screen (or
similar screens), you can access
the PARTIAL EDIT screen by
striking a pad to play the
partial and then pressing
[QUICK EDIT].
If you use the same partial for
two or more pads, editing that
partial will affect the sound of
each pad to which it is
assigned. For details, refer to If
the same partial is assigned
to more than one pad (p. 59).
To select a partial for editing,
you can strike the pad to
which that partial is assigned.