Roland MV-8000 Owner's Manual page 356

SAMPLING
8. Length
Specifies the time after which sampling will stop.
Stop Trigger
Value
parameter
Beat 1~8~20000
000m01s~000m02s~
Time
100m00s
• The Length setting is used only when Stop
Trigger= Beat or Time.
• The maximum value for Length depends on the
remaining amount of sampling memory.
9. Pre Sample Time
Specifies how much time prior to the actual start of
sampling will be captured in the sample.
Range: 0, 20, 40, 80, 160, 320, 640, 1000 ms
10. Auto Divide
The Auto Divide function detects regions of silence
within the sample, and divides the sample into
several samples at these points.
Range: Off, On
11. Gap Time
When Auto Divide=On, this parameter specifies the
length of the silent regions that will be detected.
Range: 0.5, 1.0, 1.5, 2.0 sec
The Gap Time setting is used only when Auto
Divide=On.
12. Auto Emphasis
Automatically pre-emphasis processes after
sampling.
Range: Off, On
13. Auto Normalize
Automatically normalizes the level after sampling.
Range: Off, On
14. Wave Memory
Indicates the amount of wave data stored in the
DIMM, both numerically and as a graph.
F-buttons
Sampling
Samples an external audio source. The SAMPLING
screen will appear.
Re-Sampling
356
Samples an internal audio source. The RESAMPLING
screen will appear.
Reset Peak
Clears the indicators of the peak hold in the Level
meters.
Start
Starts sampling.
If Start Trigger=Manual, sampling will begin
immediately. Otherwise, sampling will begin
according to the conditions specified by the Start
Trigger setting.
When Start Trigger = Level/Play/Pad
Cancel
Cancels the sampling operation.
Start
Manually starts sampling. A message of Now
Sampling... will appear.
When Start Trigger=Manual, or during sampling
Cancel
Cancels the sampling operation.
Stop
Stops sampling. The Sampling Result screen will then
appear.
Sampling type
Audio phrase/
patch
Sample
Screen that appears
SAMPLING RESULT (AUDIO
PHRASE/PATCH) popup (p.
357)
SAMPLING RESULT (SAM-
PLE) popup (p. 359)