Menu Display; Basic Params - Baldor VS1GV21-1B Installation & Operating Manual

6.3 Menu Display

After power-up the display shows the Status screen. Press the Menu key to display menu options.
Action
Status Display
Press Menu/Esc

6.4 Basic Params

From the Menu display screen, select Basic Params and press Enter.
Parameter Status
All programmable parameters are displayed with an "F" at the bottom center of the display. "F" means it is the factory
setting value. "C" means it is a custom value set by the user. "V" means the parameter value may be viewed but not
changed while the motor is operating. If the parameter is displayed with an "L", the value is locked and may not be changed
until the security code is entered.
Action
Basic Params Display
Press to go to the
next Basic Params
screen.
Press to go to the
next Basic Params
screen.
Press to go to the
next Basic Params
screen.
Press to go to the
next Basic Params
screen.
Press to go to the
next Basic Params
screen.
6-4 Using the Keypad
Description
Displays top level menu options.
Description
Control type display. The
parameter number "1601" is given
at the bottom center of the
display. "F"1601 indicates it is at
the factory setting and has not
been changed.
Display
STOP
STATUS
0.0V
0.0A 0.0HZ
DIAG 0.00r
STATUS
BASIC PARAMS
ADVANCED PROG
EVENT LOG
DIAGNOSTICS
DIAG
Display
MOTOR CONTROL
BASIC
CONTROL TYPE
V/F Control
STATUS F1601T1 BACK
MOTOR DATA
BASIC
MOTOR RATED HP
10.0 HP
STATUS F2416T1 BACK
MOTOR DATA
BASIC
MOTOR RATED VOLT
240.0 V
STATUS F2401T1 BACK
BASIC MOTOR DATA
MOTOR RATED AMPS
9.6 A
STATUS F2402T1 BACK
BASIC
MOTOR DATA
MOTOR MAG AMPS
3.1 A
STATUS F2405T1 BACK
BASIC
MOTOR DATA
MOTOR RATED SPD
1754 RPM
STATUS F2403T1 BACK
Comments
LOCAL
0RPM
MAIN
Press or to move cursor over
the desired selection the press
"Enter" to select and display the
selection.
BACK
Comments
Press Enter to select the
parameter and press the or
keys to change the preset value
to a di erent control type.
Press enter when nished to exit
and save the new value or F2 to
exit without saving.
T1 indicates the Table Number or
the parameter list in use. Four
parameter tables are available,
T1, T2, T3 or T4
(See Level 2, Drive Con g, Active
Param Table parameter P0052.)
MN765