Diagnostics - Baldor VS1GV21-1B Installation & Operating Manual

6.9 Diagnostics

From the Menu display screen, select Diagnostics and press enter. These are read only values with the exception of the real
time clock settings.
See Chapter 9 for a more detailed description.
Action
Press Menu
Press to display next
group.
Press to display next
group.
Press to display next
group.
Press to display next
group.
Press to display next
group.
Press to display next
group.
Press to display next
group.
6-12 Using the Keypad
Description
Displays top level menu options.
Displays active operating mode
settings.
Bit display of digital inputs,
outputs and the voltage present at
the internal 24V supply terminals.
Note: Example display shows that
the drive enable terminal
(J2-8) is on and that
Relay Out 2 is on.
Output Frequency, % Feedforward
% Setpoint, % Feedback
Displays software version, hp,
volts and Amp/Volt ratings.
Displays:
Power Base ID number
EE Firmware version
FPGA Firmware version
Displays real time clock values
(date and time) and total run time
since installation.
Press ENTER to set date and
time.
Display
STATUS
BASIC PARAMS
ADVANCED PROG
EVENT LOG
DIAGNOSTICS
STATUS BACK
STOP LOCAL
DIAG
OPERATING MODE
Keypad
Speed
V/F Control
EV. LOG 0.00r MAIN
STOP LOCAL
DIAG
DIGITAL I/O
INPUTS 100000000
OUTPUTS 0001
USER 24V 24.9V
EV. LOG 0.00r MAIN
STOP LOCAL
DIAG
PROC CONTROL PID
0.00HZ 0.0FF
0.0SP 0.0FB
EV. LOG 0.00r MAIN
STOP LOCAL
DIAG
ZHH-1.22
RATED HP 3HP
RATED VOLTS 240.0V
RATED A/V 4.0A/V
EV. LOG 0.00r MAIN
STOP LOCAL
DIAG
ZHH-1.22
RATED CURRE 9.6A
RATED PK CU 16.8A
EV. LOG 0.00r MAIN
STOP LOCAL
DIAG
POWER BASE VERSION
ID 0x000A2003
EE VER 0x00000001
FPGA VER 0x00000A02
EV. LOG 0.00r MAIN
STOP LOCAL
DIAG
REAL TIME CLOCK
Jul 4, 2006
22:07:35
RUN TIMER 474.1HR
EV. LOG 0.00r MAIN
Comments
Press or to move cursor over
the "DIAGNOSTICS" selection.
Press Enter to view diagnostic
information.
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to previous
menu.
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to previous
menu.
Note: This screen does not appear
unless P#1401 is set to Process Control.
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to previous
menu.
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to previous
menu.
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to previous
menu.
0x=Hexadecimal
0b=Binary
Press or to go to the next or
previous Diagnostic screen.
Press F2 to return to previous
menu.
MN765