6.2 Keypad Display Parameters
The following display values can be viewed from the keypad while operating the drive.
6.2.1 Default Configuration
Speed and Amps can be displayed by the drive in its default configuration.
Press the ENT/PROG key momentarily to toggle between Hertz and Amps on the display.
P-04 = 0, P-23 = 0
6.2.2 RPM Display
Setting P-04 to a value other than zero will set units for the VS1MX in RPM. This will enable a third display screen in
operational mode to show the RPM units set in parameter P-04.
P-04 = 1800, P-23 = 0
6-2 Using the Keypad
Figure 6-1 Standard Display Screen
ENT
PROG
ENT
PROG
Figure 6-2 RPM Display
ENT
PROG
ENT
PROG
ENT
PROG
MN762