D.2 Expansion Boards - Baldor VS1GV21-1B Installation & Operating Manual

D.2 Expansion Boards

Baldor offers a wide variety of plug-in expansion boards for their Controls. Expansion boards allow a control to be
compatible with various inputs and outputs. Each control can accept up to two expansion boards. Chapter 3 of this manual
describes the locations of the connectors for these expansion boards.
Catalog Number
EXBHH001A01
EXBHH003A01
EXBHH005A01
EXBHH007A01
EXBHH013A02
EXBHH014A02
EXBHH015A01
EXBHH016A01
EXBHH017A01
D-2 Options and Kits
Table D-2 Expansion Board Descriptions
Description
Ethernet Server Expansion Board
Uses standard RJ-45 female terminal for Ethernet connection. Provides easy connection
to any PC based Web Browser that has an Ethernet connection. Allows you to quickly
access all drive parameters for setup and review. Download parameter values, operating
conditions, and fault log data for review and archive.
Isolated Input Expansion Board
Contains 9 isolated inputs, jumper configurable for 90-130 VAC. All inputs must be the
same voltage. One side of all inputs is common. This board replaces all the opto inputs on
the main control board. Uses screw terminals for connection.
High resolution analog input/output board
Allows two inputs with up to 16 bits resolution. DC inputs: ±10V, 0-10V, ±5V, 0-5V, with 300
microvolt resolution. Current inputs: 4-20mA, with 0.6 microamps resolution.
Input Resolution
±10V
0 - 10V
±5V
0 - 5V
0 - 20mA
4 - 20mA
Both the 0-10V and 4-20mA inputs may be inverted to 10-0V and 20-4mA. Two outputs,
each with ±10VDC, 0-10VDC or 4-20mA with inverting capability. These are in addition
to the two analog outputs on the main control board (4 total). Uses screw terminals for
connection.
Master Pulse Reference / Isolated Pulse Follower
Jumper selection of the following modes:
1. Accepts a 5VDC or 12VDC quadrature pulse train input or pulse and direction input to
use as a master reference.
2. Re-transmits the input pulse train at 5VDC for ratios from 1:20 up to 65535:1. (Scaled
output).
3. Can be used as a auxiliary encoder input to the control.
4. A CANopen port with an RJ-45 female connector for adding an additional I/O breakout
box or CAN HMI terminal.
DeviceNet / EtherNet/IP / Modbus TCP Communications Expansion Board
Allows connection to DeviceNet Communications Bus. Allows connection to EtherNet/
IP Communications Bus. Allows connection to Modbus TCP Communications Bus. Uses
screw terminals for DeviceNet connection.
PROFIBUS-DP Expansion Board
Allows connection to PROFIBUS-DP Communications Bus. Uses 9-pin D-shell for
connection.
BACnet Expansion Board
Allows connection to a BACnet Communications Network.
Uses screw terminals for connection.
LonWorks Communications Expansion Board
Allows connection to a LonWorks Communications Bus.
Uses plug-in terminals for connection.
Metasys N2 Communications Expansion Board
Allows connection to or N2 communications network.
Uses screw terminals for connection.
16 bit
15 bit
15 bit
14 bit
15 bit
15 bit
MN765