Operating The Control From The Keypad; Accessing The Keypad Jog Command; Speed Adjustment Using Local Speed Reference - Baldor VS1GV21-1B Installation & Operating Manual

6.11 Operating the Control from the Keypad

To activate the LOCAL Mode, first press the "STOP" key (if enabled).
Note: Pressing the keypad STOP key (if enabled) will automatically issue a motor stop command and change to LOCAL
mode. Selection of LOCAL Mode overrides any remote or serial control inputs except the External Trip input, Local
Enable Input or STOP input.
The control can operate the motor from the keypad in two ways.
1. JOG Command.
2. Speed adjustment with Keypad entered values and/or Keypad Up/Down arrow keys.
Note: If the level 1, input block operating mode parameter is set to Keypad, then no other means of operation is permitted
other than from the keypad.

6.11.1 Accessing the Keypad JOG Command

Action
Status Display
Press JOG key
Next, press and hold
the FWD or REV key

6.11.2 Speed Adjustment using Local Speed Reference

Action
At the Status Display,
press ENTER key to
access Local Speed
Reference.
Press FWD or REV key.
MN765
Description
The JOG LED will light indicating
the JOG mode is active. Holding
the FWD or REV key starts JOG
operation.
Releasing FWD or REV key will
terminate motor rotation.
Description
The control will turn the motor
shaft at the local speed ref speed.
Display
STOP LOCAL
STATUS
0.0V 0RPM
0.0A 0.0HZ
DIAG 0.00r MAIN
FWD LOCAL
STATUS
24.7V 208RPM
1.3A 7.0HZ
DIAG 600 r MAIN
Display
LOCAL REFs
EDIT
LOC SPEED REF
000000 RPM
MAX F0201 RESET
EDIT
LOCAL REFs
LOC SPEED REF
000000 RPM
DIAG F0201 BACK
EDIT
LOCAL REFs
LOC SPEED REF
000600 RPM
DIAG C0201 BACK
FWD LOCAL
STATUS
86.4V 600RPM
1.3A 20.4HZ
DIAG 600r BACK
Comments
To change Jog Speed, Edit
Level 1 parameter 1201 (Jog
Speed).
Press STOP key twice to
terminate JOG mode.
Comments
or
Press to move cursor.
Press or to increase or
decrease value at cursor.
Press ENTER when nished and
save the new value.
or
Press to move cursor.
or
Press to increase or
decrease value at cursor.
Press ENTER when nished and
save the new value.
Press STOP key to terminate
local speed mode.
Press or to increase or
decrease motor speed during
rotation.
Using the Keypad 6-15