D.4 Optional Remote Keypad Installation - Baldor VS1GV21-1B Installation & Operating Manual

D.4 Optional Remote Keypad Installation

The keypad may be remotely mounted using optional Baldor keypad extension cable (refer to Table D-3). When the keypad
is properly mounted to a NEMA Type 4X enclosure, it retains the Type 4X rating. The mounting/drill template is located in
Appendix E of this manual.
CAUTION:
Tools Required:
• Center punch, tap handle, screwdrivers (Phillips and straight)
• #27 drill bit
• 1-3/8" standard knockout punch
• RTV Sealant
• (3) 6-32x3/8" screws
• (3) #6 Flat Washers
Mounting Instructions: For clearance mounting holes
1. Locate a flat 4" wide x 5.5" minimum high mounting surface. Material should be sufficient thickness (14 gauge minimum).
2. Place the template on the mounting surface or mark the holes as shown on the template (ensure template is not distorted
due to reproduction).
3. Accurately center punch the 3 mounting holes and the large knockout.
4. Drill three #27 clearance holes.
5. Locate the 1-3/8" knockout center and punch using the manufacturers instructions.
6. Debur knockout and mounting holes making sure the panel stays clean and flat.
7. Apply RTV to the three #27 clearance holes.
8. Assemble the keypad to the panel. Use 6-32 screws and flat washers.
9. From the inside of the panel, apply RTV over each of the three mounting screws. Cover a 3/4" area around each screw
making sure to completely encapsulate the screw head and washer.
10. Route the keypad cable into the control and connect to P2 of the control board, Figure D-1.
See recommended tightening torques in Table A-2.
Connector
D-4 Options and Kits
Only use cables manufactured by Baldor. Cables purchased from other sources may not be
properly wired and may damage the control or keypad and void the warranty.
Figure D-1 Connector Locations
Regen
J7
Ribbon Cable
J8
Control
Circuit Board
RS485
Keypad
S G A B S
1
JP3
Connector
P2
P3
MN765