Janome JR3000 Series Operation Manual page 97

After the source number is entered, the
destination data number (S) entry screen
appears. Enter the copy start destination
number.
NOTE: (S) indicates it is the start number.
On the destination number entry screen, press
the F2 (NEW) key to display the
unregistered number list.
Press the F3 (LIST) key to display the
registered number list. You can also select the
data you want from this list.
After you enter destination data number (S), the
destination data number (E) screen appears.
Enter the copy end destination number.
NOTE: (E) indicates it is the end number.
On the destination number entry screen, press
the F2 (NEW) key to display the
unregistered number list. Press the F3
(LIST) key to display the registered number list.
You can also select the data you want from
these lists.
The data is copied within the range of destination data number (S) – destination data number (E).
The copy source cannot be included in the destination data number (S) – destination data number (E)
range.
If data is already registered within the destination data number (S) – destination data number (E) range,
it is overwritten with the copy source data.
Once you select the copy destination range, a
copy confirmation screen appears.
If you select [YES], the data is overwritten.
If you select [NO], the screen returns to the
Teaching Data Copy, Delete, Conversion menu.
To change only the destination number, press
the ESC key on the copy confirmation
screen. The screen returns to the previous
screen (destination number (E) entry screen).
Teaching Pendant Operation
Enter a number.
Destination Data Number (S)
F0 F1
Enter a number.
Destination Data Number (E)
F0 F1
No.1
YES
F0 F1
96
NEW LIST
F2 F3
NEW LIST
F2 F3
5 – 8
Copy OK?
NO
F2 F3
Desktop Robot JR3000
5
F4
8
F4
F4