Janome JR3000 Series Operation Manual page 37

F3 ········································· Each time this key is pressed, the cursor line (indicated by ">")
CURSOR ···························· Moves the cursor one place to the left. This key is invalid if the
CURSOR ···························· Moves the cursor one place to the right. If the cursor is on the
GO ······································· Moves the axes to the coordinates displayed on the LCD. The
Caution
ESC ······································ This key is invalid when a new position is entered. Returns to the
SHIFT + ESC ····················· Goes to the current point's base screen when editing, and goes to
F0 (FUNC) ····························· Changes the F1 – F4 key functions.
F2 (JOG) ······························· Switches to JOG mode. Also, the coordinates displayed on the
F4 (INIT) ······························· Performs mechanical initialization and moves the axes to their
*If you have changed the F1 – F4 key functions by pressing the F0 key, the point jobs
assigned to the keys are performed instead. (Manual job)
Teaching Pendant Operation
switches in the following order: X
cursor is on the lowest digit. If the cursor is hidden, press this key
to display the cursor on the rightmost digit. When entering new
positions, this moves the cursor to the previous point screen.
lowest digit, pressing this key hides the cursor. This key is invalid if
the cursor is hidden.
"RUN" LED on the teaching pendant does not light up when using
the GO key to move the axes.
Always pay attention to the robot's movements when moving each of
the axes with the GO key.
point settings screen (base screen) when a position is modified.
the Point 1 base screen when entering new positions.
(To change the functions, you must set the manual job numbers.)
LCD are replaced with the current axes position coordinates.*
absolute coordinates (0, 0)*.
36
Y Z R X.
Desktop Robot JR3000